Configure the network settings of the external Ethernet connection (ETH0).
1. Connect to the user interface as the Admin user.
2. In the user interface, select Settings > Network > IP address.
3. Select if the external Ethernet connection should be Enabled or Disabled.
4. If you enabled the external Ethernet connection, select how its IP address is assigned:
DHCP for automatic assignment, or Static IP address to enter the values manually.
5. If you selected Static IP address, enter the following values:
• IP address
• Subnet mask
• Default gateway
IP addresses in 192.168.28.0/24 cannot be used for the external network
connection (ETH0) since they are reserved for the service port (ETH1).
6. Select
Apply to save your changes.
More information
‣
Connecting to user interface (page 30)
3.11
Configuring user interface security
Figure 33 Network security settings page
OPT100 User Guide M211858EN-U
56
To Next Page
Loading...