Vaisala Optimus OPT100 - Configuring Custom Averages; Figure 40 Offsets in Measurements

View oset values in Measurements page. Oset flag in the graphs shows when the newest
oset has been applied. Osets are added to measured values, 1 day averages, gas ratios and
custom averages. Oset values are also shown in DGA Diagnostics.
Figure 40 Osets in Measurements
If you have set gas level alerts, osets may cause additional alarms.
More information
‣
Configuring gas level alerts (page 53)
3.18
Configuring custom averages
Configure custom calculation of averages based on measurement points or time intervals. The
values will be calculated to the new dataset separately from the default 24 h averages.
OPT100 User Guide M211858EN-U
66