Vaisala Optimus OPT100 - Page 50

3. To set date and time manually:
a. Select Set time manually.
b. Select or enter the current date into Date. The format is yyyy-mm-dd.
c. Enter the current time into Time. The field is in 24-hour clock notation in format
hh:mm.
d. Select Apply to save the set time.
4. To set up time synchronization with a Network Time Protocol (NTP) server:
NTP synchronization requires that the network connection is configured and
the IP address of the NTP server is reachable.
a. Select
Use NTP.
b. Enter the IP address of the NTP server into NTP server.
c. Select Apply to start time synchronization.
Status of time synchronization is shown below the NTP server field. If the status
shows Connecting... and does not progress to Synchronizing time... even after
waiting for a minute, verify that the network connection is working and configured,
and the IP address of the NTP server is correctly entered.
d. Wait for the message Time successfully synchronized to appear.
5. To set up time synchronization using DNP3 protocol:
a. Enable and configure the DN3 protocol.
b. Select Use DNP3.
c. Select Apply to start time synchronization.
More information
‣
Connecting to user interface (page 30)
‣
Configuring DNP3 protocol (page 59)
OPT100 User Guide M211858EN-U
50