Vaisala PTU300 - Errs; Vers; Resetting Transmitter Using Serial Line; Reset

Chapter 4 ________________________________________________________________ Operation
VAISALA______________________________________________________________________ 115
ERRS
Use the ERRS command to display transmitter error messages, see Error
States on page 159 and Table 35 on page 160.
Example:
>errs
No errors
>
Example:
>errs
Error: E2 Humidity sensor open circuit.
>
VERS
Use the VERS command to display software version information.
Example:
>vers
PTU300 / 5.10
>
Resetting Transmitter using Serial Line
RESET
Resets the device. The user port switches to start-up output mode
selected with command SMODE.