Chapter 3 _______________________________________________________________ Installation
VAISALA_______________________________________________________________________ 61
0802-103
Figure 36 WLAN Interface Module
The following numbers refer to Figure 36 above:
1 = Flat cable connector
2 = Connector for antenna cable (connected to transmitter cover)
NOTE
The WLAN interface is not recommended for use with the PTU301 fixed
probe model (for wall-mounted applications). The PTU301 short cable
probe is designed to be used with the WLAN interface.
Attaching the WLAN Antenna
The LAN interface module must be installed at the factory (when
ordering the transmitter), or by a Vaisala Service Center. Before taking
the transmitter into use, you must attach the antenna of the WLAN
interface into the RP-SMA connector on the transmitter cover. The
location of the antenna is shown in Figure 80 on page 191.
To Next Page
Loading...
