Vaisala PTU300 - Disabling MODBUS Protocol

Chapter 5 ________________________________________________________________ MODBUS
VAISALA______________________________________________________________________ 153
a. Use the NET command to configure the networking
parameters of both LAN and WLAN Interface. You can, for
example, enter the command without parameters and enter
the settings as prompted:
>net
DHCP : ON ? OFF
IP address : 0.0.0.0 ? 143.154.142.102
Subnet mask : 0.0.0.0 ? 255.255.0.0
Default gateway: 0.0.0.0 ?
Web config. : ON ? OFF
Save changes (Y/N) ? y
OK
>
b. If you are using the WLAN Interface, use the WLAN
command to configure the network name (SSID) and security
settings. For example:
>wlan
Network SSID : NAME ? NETWORKID
Type : OPEN ? WPA-PSK/TKIP
WPA-PSK phrase ? thequickbrownfox
Save changes (Y/N) ? y
OK
>
For a description of the available settings, see section
Wireless LAN Configuration on page 87.
8. The MODBUS configuration is now complete. Reset or power
cycle the transmitter to enable the MODBUS mode, and proceed
with the installation of the transmitter.