EasyManua.ls Logo

Vaisala WINDCAP WMT52 - Chapter 4 Installation; Unpacking Instructions

Vaisala WINDCAP WMT52
143 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 4 _______________________________________________________________ Installation
VAISALA_______________________________________________________________________ 27
CHAPTER 4
INSTALLATION
This chapter provides you with information that is intended to help you
install Ultrasonic Wind Sensor WMT52.
Unpacking Instructions
Ultrasonic Wind Sensor WMT52 comes in a custom shipping container.
Be careful when removing the device from the container.
CAUTION
Beware of damaging any of the wind transducers located at the top of
the three antennas. Dropping the device can break or damage the
transducers. If the antenna bends or twists the re-aligning can be
difficult or impossible.

Table of Contents

Related product manuals