ii) Please note. When first turned on the flames will appear predominantly blue.
The ceramic fuel effect pieces will take time to warm up. Although some
glow will be seen after approximately ten minutes, the full visual effect will
only be apparent after a somewhat longer time.
iii) The appliance will operate to its maximum potential if the flue is primed
during the first 20 – 30 minutes of operation. To do this, simply slide the
control button to its highest setting. This will also burn off any carbon
deposits that may have formed during previous operations.
iv) If operating the appliance for long periods it is beneficial occasionally to
change the settings. This will also help to remove any carbon deposits that
may form during operation.
To turn the fire off.
1. Slide the button up past the high heat position to the “O” position. Both the main
burner and the pilot should go out. While cooling, the ceramic fuel effect pieces may
make some crackling noises. This is quite normal.
Lighting with a taper.
(See figure 5).
In the unlikely event of failure of the ignition spark,
the pilot can be lit by a taper or long spill. Insert
the taper or spill between the second and third left
hand ceramic fuel effect pieces on the first row.
Operate the slide control as described above.
Page 59
© Baxi Heating U.K. Limited 2009.
OWNER GUIDE
Figure 5. Lighting with a taper
(ceramic fuel effect may differ
from that shown)
To Next Page
Loading...
