Page 14
ECS-3M
Fig. 1
Two Fans (115V) and One Heating Unit (115V)
2.7 POWERING UP
Before powering up the ECS-3M, install the faceplate to
the control’s enclosure using the six screws previously
removed.
Set Selector knob to position (12).
Upon power up, the unit will test its display by briefly
lighting all the segments of its LED. Make certain that
all segments light up.
Following the LED display test, the unit displays the
room temperature.
If the temperature does not appear, refer to the
Troubleshooting section in the appendix of this
document.
To Next Page
