Page 23
PRIMARY FUNCTIONS
MAIN SET POINT
The main set point establishes the target
temperature in the building. This value is
used as the reference point for other settings.
The main set point temperature is adjusted in
0.5 degree increments from a minimum
setting of -9.5°C (13.5°F) to a maximum
setting of 41.0°C (105.0°F).
Adjusting the main set point temperature:
•
rotate the Selector dial to position (1),
•rotate the Adjuster dial counterclockwise to
decrease the temperature setting, clockwise
to increase it.
The main set point temperature is displayed on
the ECS.
1
CHAPTER 3 - USER’S GUIDE
Note: The reduction per day feature
(primary function 9) must be (OFF) to
adjust the main set point.
To Next Page
Loading...
