Installation, Operating & Maintenance Instructions
Series 650 DN 100-250 (I.D. 4“ - 10”), CC-Link
VAT Vakuumventile AG, CH-9469 Haag, Switzerland
Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com
280672EB
2010-12-15
1/94
Pendulum control & isolation valve
with CC-Link interface
with valve cluster functionality
This manual is valid for the valve ordering number(s):
650 . . - . . TL - . . . . (Master / 1 sensor input)
650 . . - . . TN - . . . . (Master / 2 sensor inputs)
650 . . - . . VL - . . . . (Master / 1 sensor input / ±15V SPS)
650 . . - . . VN - . . . . (Master / 2 sensor inputs / ±15V SPS)
650 . . - . . UL - . . . . (Master / 1 sensor input / PFO)
650 . . - . . UN - . . . . (Master / 2 sensor inputs / PFO)
650 . . - . . WL - . . . . (Master / 1 sensor input / ±15V SPS / PFO)
650 . . - . . WN - . . . . (Master / 2 sensor inputs / ±15V SPS / PFO)
650 . . - . . GS - . . . . (Slave)
650 . . - . . HS - . . . . (Slave / PFO)
SPS = Sensor Power Supply PFO = Power Failure Option
Master and Slave are configured with firmware 650C.1E.12
The fabrication number is indicated on each product as per the label
below (or similar):
made in Switzerland
Fabrication No.:
patented
Fabrication number
sample picture
Explanation of symbols:
Read declaration carefully before you start any other
action!
Keep body parts and objects away from the valve
opening!
Attention!
Hot surfaces; do not touch!
Product is in conformity with EC guidelines,
if applicable!
Loaded springs and/or air cushions are potential
hazards!
Disconnect electrical power and compressed air
lines. Do not touch parts under voltage!
Wear gloves!
Read these «Installation, Operating & Maintenance Instructions» and the enclosed «General
Safety Instructions» carefully before you start any other action!
To Next Page
Need help?
General
