Vector Revolution 180 - Page 28

151 pages

To Next Page

To Previous Page

Assembly 5

________________________________________________________________________________________

_______________________________________

5-4

Main Page

Table of Contents3
Technical Data7
Characteristic Data7
Weight7
Scope of Application, Operation and Intended Use7
Scope of Application7
Operation7
Intended Use7
Machine Dimensions8
Working Dimensions10
Connected Load (Basic Machine = Units)10
Ambient Conditions10
Electronic Devices10
Compressed Air10
Safety11
Symbol and Explanation of Directions11
Definitions11
Correct Use11
Residual Risk11
Proficient Personnel11
Qualified Personnel12
Protective Clothing12
Working Safety Directions12
Protective Devices14
Residual Risks14
Emergency Measures15
General Information15
Fire Hazard15
First Aid16
General17
Introduction17
Application17
Copyright18
Address18
Warranty18
Transport, Offloading, Setting up19
General Instructions19
Space Requirement19
Setting up Area19
Sensitivity19
Ambient Conditions19
Transport Routes19
Interim Storage20
Cleaning20
Transport from Packaging to Location20
Transport Means20
Offloading20
Levelling24
Assembly25
General Instructions25
Machine Assembly25
Re-Fitting of Components Removed for Transportation25
Fitting X Axis Counter32
Fitting Emergency Stop Pullwire34
Fitting Edgeband Coil Support35
Machine Connections38
Electrical38
Cross Section of Connection Cabling and Input Pre-Fusing38
Pneumatic38
Testing End-Limit Switches39
Testing Axis Counting Direction (X + Y)40
Preparations for No-Load Tests Without Workpieces41
Mechanical41
Electrical (Provided by Others)41
Checking the Direction of Rotation42
General Description43
Design43
Mode of Operation44
Operation Panel45
Control Fields / Control Elements45
Definition of Control Elements45
Start up49
Putting the Basic Machine into Service49
Switching on49
Switching off51
Emergency Cut-Out52
Power Failure52
General Reset52
Preparation for Operation54
Loading Tape Coil, Feeding Tape, Setting Guide Height, Setting Infeed Top Bar54
End Trimming Band58
Turning on the Glue and Setting Height to Match Panel Thickness62
Setting Glue Height to Match Panel Thickness64
Setting Glue Start and Stop Adjustments65
Setting Glue Pressures and Tape Presser67
Setting the Nozzle Wiper68
Loading a Glue Cartridge69
Manually Purging Glue Cartridge74
Selecting 360 Degree Setting for Butt Joint or Open Board76
Degree Operation77
Commencing a Cycle88
Saving Start Positions91
Single or Pendulum Operation95
Start Cycle96
Start Prevent Messages97
Setting Trimmer Shoes101
Setting the Glue Joint Scraper107
Advanced Controls112
Advanced Controls: Glue113
Advanced Controls: Trimmer114
Advanced Controls: Scraper115
Advanced Controls: Feed116
Advanced Controls: 360 Panel118
Advanced Controls: Panel Shapes119
Cycle Functions120
Standard Conditions122
Convex (External) Corner122
Concave (Internal) Corner125
Aggregate Pushed Back by Bump Bar126
Aggregate Retracted by Bump Bar127
Special Sequences132
Setting Trigger Points133
Setting up Special Sequences134
Functions Page136
Save/Load Settings138
Alarms140
Care and Maintenance141
General Instructions141
Maintenance Chart142
Troubleshooting and Remedies147
Simple Fault Schedule147
List of Alarms149
Start Prevent Alarms150
Notes151

Vector Revolution 180 - Page 28

Table of Contents