Vectronix PLRF10C - Options and Interface Settings; Setting Interface Options

Options PLRF10C/15C-2.0en
46
Options
Interface Settings
Various interface settings can
be set. Click the azimuth key six
times in rapid succession.
"IF" appears briefly in the field
of view, followed by the current
setting.
If "IF" doesn‘t appear, no
options are enabled.
Click the distance key until the
desired interface setting
appears. The choice depends
on enabled options.
The various settings are
described in detail on the
following pages.
Click the azimuth key six times
in rapid sucession to store the
setting.
The message "OldC" is
displayed if the setting was not
stored.