Vectronix PLRF10C - PLGR+96; PLGR II Specific Settings

Options PLRF10C/15C-2.0en
48
PLGR+96 / PLGR II Settings
Setting the PLRF10C/15C
•Store the Interface setting "PLGr".
!
When used with PLGR declination must be
set at "0" (see pages 30 )
Setting the PLGR+96 / PLGR II
•Set the tracking mode to CONT.
•Select the position format which corresponds to
the map being used.
•Select the appropriate ELEV units.
•Select the appropriate ELEV reference.
• Select the appropriate ANG units.
•Select the ANG reference (Grid).
•Select the datum which corresponds to the map
being employed.
!
The proper datum must be selected.
Improper datum selection will result in
poor target position accuracy.
•Set the AUTOMATIC OFF TIMER to OFF.
•Set the SERIAL mode to standard.
Additional setting for PLGR II
•Configure port C to IP.
• Configure the remaining ports to IP (or
RTCM-NMEA).
•Set the port C baud rate at 9600-9600.
•Change the LRF mode to TARGETING.
!
Azimuth in PLRF10C/15C and Azimuth
on PLGR+96 / PLGR II will be different
due to declination angle.
If attempting to use PLGR while "PC" is set, the
warning "PC" flashes in the field of view.