Vega VEGAPULS 63 - 5 Connection Adapters & Switch-on; 5.4 VEGADIS-Adapter & 5.5 Switch-on Phase

31
5 Connecting to power supply and bus system
VEGAPULS 63 • Modbus and Levelmaster protocol
41364-EN-170711
5.4 Double chamber housing with
VEGADIS-Adapter
3
1
2
Fig. 20: View to the electronics compartment with VEGADIS adapter for connec-
tion of the external display and adjustment unit
1 VEGADIS adapter
2 Internal plug connection
3 Plug connector M12 x 1
34
1
2
Fig. 21: View to the plug connector M12 x 1
1 Pin 1
2 Pin 2
3 Pin 3
4 Pin 4
Contact pin Colour, connection ca-
ble in the sensor
Terminal, electronics
module
Pin 1 Brown 5
Pin 2 White 6
Pin 3 Blue 7
Pin 4 Black 8
5.5 Switch-on phase
After VEGAPULS 63 is connected to the bus system, the instrument
carries out a self-test for approx. 30 seconds. The following steps are
carried out:
•
Internal check of the electronics
•
Indication of a status message, e.g. "F 105 Determine measured
value" on the display or PC
•
Statusbytegoesbrieytofaultvalue
Electronics compartment
Assignment of the plug
connector