3.7 fuel cap
The fuel cap will be installed in the highest corner of the fuel tank area. Locate the
desired position and hold the cap against the inside surface of the liner and draw around
the perimeter. Cut the inner liner to the edges of the mark, clean the core material without
damaging the outer liner.
Rough the coating areas around this cut and the metal surfaces of the fuel cap in the
glued areas, clean the debris from the area. Cover with FLOX around the cut area,
working it into the core material and seat the cap in place. Cut a three-ply “washer” from
wet BID and laminate around neck (3 inches beyond lid surface). Work with this BID on
all joint areas and remove any bubbles from the lamination.
To Next Page
Loading...