After curing remove the outer coating from inside the cap and finish.
3.8 tank bridge
Take the pipe sections for the bridge and laminate them with two BID layers. Allow
healing. Drill 2 holes of 1 ½” with center to 7/8” the top and bottom edges and the 1”
from the trailing edge of the ribs of the BL 118 and BL 125 . Pass the PVC pipe sections
through these holes. Moisten the hoving with resin and 3 to 4 turns on the non-flange side
of the ribs, on the flanged side stick in place with a FLOX paste. Remember to keep
sections apart 7 inches. Allow healing.
To Next Page
Loading...