Veloce 400 - Page 3

3.16 Trailing edge strengthening 22
3.17 Hinges Installation 23
3.18 Aileron horn 23
3.19 Wing tips Installation 24
4 Horizontal empennage 25
4.1 Assembly Preparation 26
4.1.1 Horizontal stabilizer spar 28
4.1.2 Elevator spar 20
4.1.3 Ribs preparation and positioning 30
4.1.4 trim-tab hinge region preparation 32
4.2 Component lamination 33
4.2.1.1 Spars lamination 33
4.2.1.2 Elevator Spar 33
4.2.1.3 Stabilizer spar 33
4.2.2 Ribs Lamination 33
4.2.3 Trim-trab hinge preparation 35
4.3 Top coating mounting and installation 35
4.4 Elevator and stabilizer cutting sections 37
4.5 Trim Tab 37
4.6 Trim tab hinge 37
4.7 Surfaces closing lamination 38
4.8 Elevators hinge 39
4.9 Assembly of the elevator control horn 40
4.10 Closing of edges 40
4.11 Mass balance 41
4.12 Trim-tab actuation servo 42
5 Fuselage 44
5.1 Preparation of components 44
5.2 Leveling and fixing 45
5.2.1 Wedge Rods 46