This cave will also require a hard point for mounting the rudder winch. Cut a 3-inch
square of ¼” thick plywood and cut the same size cladding on the back face of the cave,
as shown in the figure. Insert the plywood with a MICRO folder , cover the back face
with 4 layers of BID large enough for a complete overlap around the patch and extending
outwards to the edge of the frame (the front 4-layer reinforcement will be glued when the
frame is permanently installed) as shown in the figure (this rigid point will support the
winch rudder which can have a high load sometimes applied by the pilot's feet).
Pasting this will be done at a later stage.
To Next Page
Loading...