18
0900‑5017‑ETEE REV‑05
ATTAcH THE MONITOR TO THE WORKSTATION
1. Assemble the workstation according to its included instructions.
2. When attaching the quick‑release locking plate, ensure the (4) screws are fully tightened and the locking
plate is securely attached to the monitor.
Note: The screws and hex driver are included with the workstation.
3. Slide the locking plate of the monitor onto the quick‑release mount. When properly situated, the monitor
sits securely on the mount and the quick‑release locking tab locks into the quick‑release mount.
4. To remove the monitor, press the locking tab and lift the monitor off the mount.
1
2
To Next Page
Loading...
