5. Additional functions
5.1 Printout of the data of terminal and point of sale
In order to facilitate the communication with the Customer Service Office the printout including the identification
data of the terminal and point of sale can be made:
• TID
• MID
• model of device
• version of application installed on the terminal
• name and address of point of sale
The function is available from the main screen of the application:
FIGURE 62 PRINTOUT OF THE DATA OF TERMINAL AND POINT OF SALE
5.2 Automatic return to main screen and screen saver
In order to reduce the energy consumption the application is equipped with the function of the automatic return
to the main screen and the screen saver.
When the terminal is unused and displays the main screen of the application, after 20 seconds of the inactivity
the screen is dimmed, and after next 10 seconds - it is darkened, and the screen saver appears on the display
(usually the Provider’s logo is set up).
In order to start the transaction, enter the first digit of the amount – the application backlights the screen of
terminal and displays the entered digit.
If the user, after the previous function (e.g. after the printout of the report), did not return to the main screen by
pressing CANCEL, after 30 seconds of the inactivity the application switches to the administration menu, and
after next 30 seconds – to the main screen. This allows the User to start immediately the transaction without
navigating the application in order to switch to the main screen.
5.3 Time synchronisation with host
The application allows synchronising the date and time set on the terminal with the Provider’s authorisation
host. The date and time are synchronised during every transaction.
To Previous Page
Loading...
Need help?
General
