FIGURE 8 TRANSACTION LIMITS – ERROR MESSAGES
3.1.3 Entering the card and the payment methods
The payment application installed on the terminal allows making payments with all the types of cards currently
available on the market – i.e. microprocessor and proximity cards as well cards with magnet strip.
The application supports also the mobile payments – made by means of a mobile phone on which a specially
configured application (e.g. BLIK, AndroidPay etc.) is installed.
The individual card insertion methods are described below.
3.1.3.1 Electronic (microprocessor, chip) cards
The Vx520 terminal is equipped with the microprocessor card reader for reading the data from the card chip.
After the start of the transaction, confirmation of the amount and display of the card insertion request, insert the
cards into the reader in the terminal (microprocessor upward) in a manner shown in figure below.
FIGURE 9 INSERTING THE ELECTRONIC CARD
In the basic procedure, after the insertion of the card, the application informs about the data processing, then,
depending on the type of the card and transaction, displays the PIN entry request, or starts connecting with the
Authorisation Centre.
The payment card microprocessor is provided with applications for the various transactions performed with the
card.
• Selecting the application on the card
The certain cards may be provided with more than one application (the applications on a single card may be
related to several various Client’s accounts, e.g. with the debit account and credit account). In such a case:
The entered sales amount is too high
The entered cash withdrawal amount is too low
Inserting the card into the reader
To Next Page
Loading...
Need help?
General
