1: Overview
2 Verint Video Intelligence Solutions
About the S2750e Series
The S2750e series offers many models to cover your system needs:
S2750eN—An IP camera working in the NTSC video standard
S2750eP—An IP camera working in the PAL video standard
Unless otherwise specified, the word S2750e refers to any of these devices.
Key Features
The S2750e offers the following features:
One analog video output for aiming and focusing during installation
The choice of either power over Ethernet (PoE) or 12V DC
Up to 30 frames per second with the MPEG-4 and MJPEG codecs
480 TVL, 1/3 inch Sony CCD sensor
4 to 9 mm varifocal lens, with DC auto-iris
Triple axis lens adjustments
Clear (default) or smoked cover
Integration with the Nextiva enterprise video management solution
Security
Every camera comes with a unique SSL (Secure Sockets Layer) certificate for securing its IP
link. SSL is a commonly used protocol for managing the security of IP message
transmission. Therefore, the connections with another device, the SConfigurator tool, or a
video management software can be secured.
If enabled, the SSL protocol secures the I/O and VSIP (a proprietary protocol)
communication data. It does not apply to video transmission.
Once a camera is in secure mode, you cannot access it anymore with Telnet, you access its
web interface in secure mode only, and you cannot perform firmware updates through the
IP network on it. However, you can configure it with SConfigurator.
For more information about this security feature, refer to the SConfigurator User Guide.
Video
The available video frame rates of each encoder IP camera are:
NTSC—1 to 7, 10, 15, or 30 frames per second (fps)
PAL—1 to 6, 8, 12, or 25 fps
To Next Page
Loading...
Need help?
General
