Verint Video Intelligence Solutions 17
Nextiva S2750e Series User Guide
You should take into consideration the following facts regarding firmware update using the
IP network:
It can be deactivated in the command line interface (CLI) or the web interface.
Ensure that the IP link is stable before starting the procedure; therefore it is not
recommended to perform it over the Internet.
Performing a Reset
You can perform two types of reset on the S2750e device:
A hard reset that will assign the factory default settings to the device (listed in
Appendix A on page 37). All user-defined values will be lost. Following such a reset, you
will need to reprogram the device (for instance, its IP address and VSIP port) for proper
operation within its network.
A soft reset during which the device will retain its configuration.
To perform a hard reset:
1. Remove the dome cover.
2. Press and hold the Reset button (located on the service board), until the system status
LED flashes red very rapidly (it can take up to 10 seconds).
3. Hold the button for an additional five seconds, until the LED turns off.
The device reboots. It is ready for use with the factory default settings.
4. Put the dome cover back.
To perform a soft reset:
Press and hold the Reset button one second.
The device reboots, while retaining its configuration.
Status LED
The system status LED is a bicolor (green-red) LED providing detailed information on the
current state of the device.
Note: The status LED is only visible when the dome cover is removed.
Condition Indication
Steady red for 5 sec. The device is powering up.
Flashing red (1 sec.
intervals)
The IP address of the device is already assigned to another
device on the network.
To Next Page
Loading...
Need help?
General
