3: Using the Web Interface
30 Verint Video Intelligence Solutions
VSIP Port—The communication port used by the device. The default value of all Nextiva
devices is 5510.
VSIP Multicast IP Address—The IP address used by the device to listen for VSIP queries.
The current multicast address is 224.16.32.1 and should not be changed.
VSIP Discovery IP Address—The IP address used by the device to make its presence
known with the broadcast method. The broadcast address is 255.255.255.255.
VSIP Unit Name—The name of the device.
System Time
You can set the following parameters relative to the system time:
NTP Server Usage—To enable or disable the use of the Network Time Protocol (NTP) to
get the current time. NTP uses GMT to synchronize device clock time.
NTP Server IP Address—The IP address of the NTP server from which the device will get
the current time.
NTP Server IP Port—The IP port of the NTP server. Default is 123.
Local Time Offset—The offset in minutes from the GMT time in the current time zone
(for instance, the offset for the Eastern Standard Time is -300 minutes).
Note: VSIP ports 9541, 65500, and those under 1024 are reserved and should not be
used, not even for serial port, video, or audio communication. The maximum
value is 65535.
To Next Page
Loading...
Need help?
General
