Verint Video Intelligence Solutions 13
Nextiva S2750e Series User Guide
Windows 2000 Service Pack 2 or higher, or Windows XP Service Pack 2 or higher
Setting Camera Parameters
c
The first step in configuring is to provide a typical initial configuration of its network
parameters (including its IP address) to ensure compatibility with an existing network; for
more information about the network parameters, refer to the SConfigurator User Guide.
The default IP addresses of all devices are based on the APIPA (Automatic Private IP
Addressing) addressing scheme and will be in the range 169.254.X.Y, where X and Y are
relative to the MAC address of the individual device; for more information about APIPA, see
page 39.
To work properly, devices on the same network must have unique IP addresses. The device
will not prevent you from entering a duplicate address. However, its system status LED will
turn to flashing red (1-second interval); then the device will use an APIPA address. You
then need to configure it with a proper IP address.
c
To set the parameters of an IP camera:
1. Power the camera and establish its Ethernet connection.
2. Start SConfigurator.
The SConfigurator window appears.
3. In the General tab, click Program Options.
The Program Options window appears.
4. Check Detect All Units on LAN.
5. Ensure that the VSIP Port is 5510; otherwise, click Default.
Warning: Never use PoE and 12V DC at the same time.