2: Mounting and Configuring the IP Camera
10 Verint Video Intelligence Solutions
4. If the camera uses 12V DC:
a. Establish its Ethernet connection by plugging a cable (straight-through or
crossover) between the RJ-45 connector at the end of the Ethernet cable and a
device.
The crossover cable is to directly connect the device to a computer; the
straight-through cable is to integrate the camera on a network. For their detailed
pinouts, see page 45.
b. Tie together the camera power wires to those of the power supply (see page 8).
5. If the camera uses PoE, perform the power and Ethernet connection (see page 8).
Adjusting the Image
After installing the camera, adjust the image to point to the location to be monitored and to
control parameters for low light scenes.
You can perform the following adjustment operations:
Direction (every axis can be adjusted at steps of 1.5 degrees):
Pan: 360 degrees
Tilt: 90 degrees
Rotation: 360 degrees
Field angle (zoom)
Focus
Back light compensation (BLC): To compensate in cases where a subject with a large
amount of background light would otherwise be obscured by blooming or silhouetting.
Turbo mode for automatic gain control (AGC): To amplify the video signal more than
with the normal AGC setting; this normal setting is the default in the S2750e camera.
AGC helps maintain a constant video signal even if there are changes in brightness.
To adjust the image:
1. Power the camera.
2. Remove the dome cover by pressing firmly then pulling.
3. To adjust the image using live video, use either an analog test monitor or the live video
feature of the web interface (see page 32):
To use a test monitor, plug its connector into the 2.5 mm video jack on the service
board of the camera, using the supplied video output adaptor.
To view live video using the web interface, establish the Ethernet connection of the
camera.
To Next Page
Loading...
Need help?
General
