Verint Video Intelligence Solutions 9
Nextiva S2750e Series User Guide
3. Connect another Ethernet cable (straight-through or crossover) into the DATA port of
the injector.
The crossover cable is to directly connect the device to a computer; the
straight-through cable is to integrate the device on a network. For their detailed
pinouts, see page 45.
4. Connect the other end of the second cable into an Ethernet device (for example, a
switch).
5. Power the device by plugging the power cord between the injector and the outlet.
To install the camera:
1. If you are mounting the camera on the ceiling or wall, install the dome base on the
mounting surface, using four screws (not supplied); for their specification, see page 6.
2. If you are mounting the camera on an electrical box, use two screws (not supplied).
3. Feed the cables through the bottom or side hole on the outer case. Ensure that the
cables exit out of the hole without being crushed.
Warning: To avoid damaging your Ethernet equipment, ensure that the cable is
connected into the DATA port of the PoE injector, and not in the DATA & PWR
port.
Note: The combined length of the two Ethernet cables cannot exceed 328 feet
(100 meters).
To Next Page
Loading...
Need help?
General
