3: Using the Web Interface
24 Verint Video Intelligence Solutions
Security
The security settings are relative to the protection of the device:
Telnet Session—To enable or disable the access to the CLI of the device with Telnet.
XML Report Generation—To enable or disable the generation of an XML report
presenting the current state of the device.
IP Firmware Update—To enable or disable the performance of firmware updates on the
device through the IP network. This type of firmware update is the only one available
for the devices.
HTTP Access—To enable or disable the access to the web interface of the device. If you
block this access, you can only set up the device with SConfigurator or Telnet.
Secure HTTP Access—To enable or disable the access to the web interface of the device
in a secure SSL context. If this context is enabled, you access the device with https://
in your web browser and the user account mode is automatically activated (described
on page 23).
Global Security Profile—To enable or disable the complete SSL security on the device.
Once this profile is activated on a device:
You cannot access it anymore with Telnet.
You cannot perform firmware updates through the IP network on it.
You access its web interface in a secure mode (that is, the secure HTTP access
mode is enabled).
SSL Passkey—The password to secure the connection with the device. The passkey
must be the same for all devices and the software tools to allow proper secure
communication between them.
Note: You should not change this passkey with the web interface, since there could be
eavesdropping on the network. You can use SConfigurator or a video
management software to change it.
To Next Page
Loading...
Need help?
General
