Summit & Summit 800
Feature Description and Operation Manual Issue 1.2
244
2.79.2.6 Net Conference
Description
You can join stations and outside Lines from other networked systems to a conference call with
other stations or CO lines.
Operation
iPECS IP & LDP Phones
To establish an ad-hoc conference
1. Establish the first call.
2. Press the [CONF] button. The LED will light, the connected party is placed on exclusive
hold and you receive dial tone.
3. Place the second call.
4. When connected, press [CONF], the new call is placed on exclusive hold.
5. Repeat Steps 3 and 4 above to add additional conference parties.
6. Press the [CONF] button to establish conference.
To place a conference on hold
1. Press the [HOLD/SAVE] button, the [CONF] button LED will flash.
To retrieve held conference
1. Press the flashing [CONF] button, all parties reconnected.
SLT
To establish an 3-party conference
1. Establish the first call.
2. Momentarily press the hook-switch, the connected party is placed on exclusive hold and
you receive dial tone.
3. Place the second call.
4. When connected, momentarily press hook-switch twice in 2 seconds to connect all parties.
Conditions
1. Multi-line conference time is not applied on 3-party Net Conference.
2. A SIP phone cannot initiate a Net Conference.
Programming
Keyset Admin.
SYSTEM Networking Basic Attribute (PGM 320)
Networking CO Line Attribute (PGM 322)
Network Numbering Plan Table (PGM 324)
To Next Page
Loading...
