Summit & Summit 800
Feature Description and Operation Manual Issue 1.2
271
2.84 Wake-up Alarm, Standard
Description
The standard Wake-up Alarm feature allows you or an Attendant to set a Wake-up alarm or
desired time to be alerted. When the time is reached, the system will signal your station with an
audible and visual signal.
Operation
Attendant
To register a Wake-Up Alarm
1. Press the [TRANS/PGM] button.
2. Dial “044”, the Attendant Set Wake Up code.
3. Dial the desired station range, for a single station, enter an “*” in place of the second station
number.
4. Dial the 2-digit hour and 2-digit minute for alerting.
5. For a daily (repeating alarm), dial “#”.
6. Press the [HOLD/SAVE] button.
To erase Wake-Up
1. Press the [TRANS/PGM] button.
2. Dial “045”, the Attendant Erase Wake-up code.
3. Dial the desired station range, for a single station, enter an “*” in place of the second station
number.
4. Press the [HOLD/SAVE] button.
iPECS IP & LDP Phones
To register Wake-Up
1. Press the [TRANS/PGM] button.
2. Dial “41”, the Set Wake-up code.
3. Dial the 2-digit hour and 2-digit minute for alerting.
4. For a daily (repeating alarm), dial “#”.
5. Press [HOLD/SAVE] button.
To stop the alarm notification
1. Lift the handset or press the [SPEAKER] button.
To erase Wake-Up
1. Press the [TRANS/PGM] button.
2. Dial “42”, the Erase Wake-up code.
3. Press the [HOLD/SAVE] button.
To Next Page
Loading...
