Figure 2-14 Fixing holes of the cabinet
Install bolts in the four holes at the bottom to fix the cabinet onto the floor bracket of the machine room.
Install bolts in the four holes at the top to fix the cabinet to connect the cabinet with the top bracket of the machine
room.
Cabinet Connection
The cabinet connectors come along with the accessories. Connect the unit with adjacent cabinets using the cabinet
connectors. The following section depicts the procedures for connecting the cabinet:
Before connecting the cabinet, level the cabinet as mentioned in the earlier section (Refer to section Leveling the
cabinet for in-depth information).
Loosen the fixing screw of the cabinet connector on the frame of the cabinet.
Rotate the cabinet connector 90 ° to the horizontal position. Use M5 countersunk head screws to fix it on the cabinet
frame. (Side of the door lock) as depicted in Figure 2-15.
Figure 2-15 Rotating the Cabinet connector
Use the M5 countersunk head screws to fix the cabinet connector (L-shaped) in the installation holes of the cabinet
frame (side of the hinge) and rack frame adjacent to the cabinet as depicted in Figure 2-16.
To Next Page