Vertiv Liebert S600E - Page 41

USER MANUAL-S600E
40
S600E
Figure 4-7 Initial Start-up Guide (4)
End page
Figure 4-8 Prompt for removing REPO terminal
The interface shown in Figure 4-9 will appear. This means that the function keys and LCD are invalid; the user
cannot continue with the operation. Please switch the UPS off based on the prompt shown in Figure 4-10, confirm that
the actual wiring method applied to the output terminal is consistent with the method selected during the set- up
procedure, and then switch the UPS on again.
After start-up the user will be able top operate the UPS normally.
Figure 4-9 Initial Start-up Guide (5)
In
the
case
of
the
output
page,
the
REPO
termin
al
(forcible
output
shut
-
down)
must
be
unplugged
when
carrying
out
the
settings, otherwise the interface shown in Figure 4-8 will appear.