Vespa LX Series User Manual

- Disconnect the two connectors of the magneto
flywheel cable harness and slide them from the
bottom.
- Remove the ground lead and the positive cable
from the starter motor shown in the figure.
- Open the clamp indicated and remove the throttle
body cables.
- Undo the three screws, with anti-tampering de-
vice, that fasten the intake manifold on the head.
- Detach from the head the manifold with throttle
body and commands and collect the gasket.
- Unscrew the engine pin-swinging arm nut on the
right-hand side of the vehicle and slide off the pin
on the left hand side
- Support the vehicle adequately (with a jack) and
remove the shock absorber lower clamping. The
engine is now free.
Vespa LX 125 - 150 i.e. Engine from vehicle
ENG VE - 89

Vespa LX Series Specifications

General

Displacement	124 cc
Cooling System	Air-cooled
Front Tire	110/70 - 11"
Rear Tire	120/70 - 10"
Seat Height	785 mm
Kerb Weight	114 kg
Wheelbase	1, 280 mm
Length	1, 770 mm
Width	705 mm
Height	1, 140 mm
Engine Type	Single-cylinder, 4-stroke
Fuel System	Carburetor
Max Torque	10.4 Nm @ 6, 000 rpm
Transmission	Automatic
Front Suspension	Single-sided trailing arm with hydraulic shock absorber
Rear Suspension	Hydraulic shock absorber
Front Brake	200mm disc brake
Rear Brake	110mm drum brake