Safety
14
Maintenance
Comply with the service and maintenance intervals given in the
instructions
Comply with the intervals for service and maintenance as given in the
instructions.
By complying with the maintenance intervals you assure that the
machine will operate without malfunctions and give maximum
protection to the surroundings.
An incorrectly maintained machine is a danger to its surroundings.
Always use original spare parts on the machine
Always use original spare parts.
Original spare parts should be used for safety reasons
The manufacture warranty becomes void if non-original spare parts
are being used.
High risk when performing service and maintenance work
When performing service or maintenance work there is a higher risk
of injury.
Adherence to the above instructions will ensure your own safety and
that of others.
Failure to follow the above instructions may result in serious injuries.
Therefore, when you perform maintenance work:
• Disconnect the P.T.O shaft.
• Depressurise the hydraulic system.
• Stop or disconnect the tractor.
• Check that the machine is parked safely, support it if necessary.
• Do not use parts on the machine to climb the machine, but employ
the proper units for climbing.
Disconnect the power source when working on the electrical
systems
Always disconnect the power source before you start working on the
electrical system.
This will prevent short circuits and damage to the electric circuit.
There is a risk of burns and other serious injuries if the electrical
systems short circuit.
Replacing the hydraulic hoses
Replace the hydraulic hoses at least once every 4 years.
Hydraulic hoses also wear without any visible damage.
Defective hydraulic hoses may cause serious injury.
95-009
To Next Page
Loading...
