Maintenance
55
Service - check
Cutterbar
Safety concerning maintenance work on the cutterbar
When working on the cutterbar, the tractor must be stopped and
secured.
This prevents the machine from suddenly starting to rotate.
If the tractor and the PTO shaft have not been connected in
accordance with the instructions serious accidents causing damage to
limbs can occur.
When working on the cutterbar:
• The tractor engine must be stopped.
• The ignition key must be removed.
• The PTO shaft must be disconnected.
• The tractor hydraulic system must be disconnected.
• The hand brake must be activated.
Be careful when using oil
Use barrier cream or protective gloves when handling oil.
It will protect your hands against skin injuries.
Direct contact with the oil could lead to serious skin injuries.
Use the correct oil type
Always use the correct oil type for the transmission.
This will ensure the transmission has a long service life.
Using the incorrect oil type may damage the transmission.
Maintain correct oil level
The maximum and minimum oil level indicators on the transmission
must not be exceeded.
Correct transmission oil level will ensure a long service life.
Incorrect oil levels can cause the transmission to overheat, resulting
in serious damage.
To Next Page
Loading...
