Cleaning
44
Cleaning
Use the correct cleaning agents
Use only PH neutral cleaning agents when cleaning the machine.
PH neutral cleaning agents give your machine maximum protection.
Cleaning agents with either high or low PH value can be corrosive on
plastic, rubber and varnished surfaces.
• High pressure cleaning equipment may be used to clean.
However, the area around the bearings should be cleaned using
gentle squirts of water.
• Hydraulic components should only be cleaned with gentle squirts
of water to protect the gaskets.
After cleaning
• Let the remaining water run off for about 1 hour.
• Remove the collected water behind all guards.
To Next Page
Loading...
