Safety
15
Be careful when cleaning with high pressure cleaning equipment
Do only clean bearings, hydraulic hoses, plastic components,
electrical control boxes and electrical equipment with low water
pressure.
By cleaning with low water pressure you will protect sensitive
equipment on the machine.
Using high water pressure to clean could damage vital parts of the
machine.
Disconnect the battery and the alternator before welding
The tractor battery and alternator should be disconnected before
performing welding work on the machine.
This will protect the tractor alternator during welding work.
The tractor alternator could be damaged or destroyed if the electric
connections are not disconnected before performing welding work.
Tighten all fittings on moving parts
Check that bolts on moving parts are tightened after performing
maintenance work.
Tightening parts prevents moving parts jarring.
Parts which are not correctly tightened can work loose and damage
the machine.
Do not alter the machine construction
The technical construction of the machine should not be altered and
machine maintenance should be performed.
A well maintained machine will offer maximum protection.
A poorly maintained machine will not offer proper protection and could
be dangerous.
Further safety
instructions
Follow the instructions when working on the machine
The machine safety instructions must always be followed.
This will protect you and others from injury.
Failure to follow the safety instructions may result in serious injuries.
Apart from the safety instructions the following should be complied
with:
• Environmental legislation.
• The general technical, medical and road act regulations.
• Instructions in this instruction manual.
• Instructions for use, maintenance and service.
95-018
95-005
To Next Page
Loading...
