Victoria Arduino BLACK EAGLE VA388

4 Keep the key pressed until the screen
changes.
6 Exit configuration by pressing the "Home"
button.
5 Set the various parameters using the scroll
wheel to move through the various options:
t Operating mode
t Machine units
t Left autosteam
t Right autosteam
t Auto-level with pump
t Hot water with pump
t Level sensitivity
t %FMJWFSZMFWFM
t Calib. of steam probe 1
t Calib. of steam probe 2
t Pressure calib.
t Clock calib
t Serial connection
t Pre-infusion (Gravimetric version only)
t %FMBZFEUBSF(SBWJNFUSJDWFSTJPOPOMZ
NOTE
In the latest versions of the Gravimetric VA388
the options for pre-infusion and delayed tare
are found in the "Technical settings" menu.
Edition 01 of 08/2017
10.7
SERVICE MANUAL
Avi VA TFT
Release firmware: 0.14
VA T3 V
Release firmware: 0.23
Internal temperature: 20°C
Technical settings
Fig. 356
Menu PrincipaleTechnical settings
Autoleveller pump
Hot water pump
Sensitivity level 1
Delivery level
Fig. 358
Menu PrincipaleTechnical settings
Operating mode T3
Machine groups 3
Cup warmer left off
Cup warmer right off
Fig. 357
Menu PrincipaleTechnical settings
Calib. of steam probe 1 1
Calib. of steam probe 2 2
Pressure calib. 0
Clock calib. 0
Fig. 359