2.1.4 CONNECTION TO WATER
SUPPLY
The machine comes with a loading tube with a
3/8-inch connection for the water main.
The cable is already installed in the machine,
simply connect it to the water supply.
Verify that the water inlet pressure is between
2 and 5 bars. If the pressure is higher, insert a
pressure reducer upstream to ensure a pressure
reading within the values indicated.
To connect the drain, simply insert the draining
pipe supplied to the waste water collector and
tighten the connector by hand.
Edition 01 of 08/2017
2.5
SERVICE MANUAL
Fig. 18
Fig. 19
Fig. 20
To Next Page
Loading...
