59
Installing SCSI drivers
Note:
On Windows™ 2000 computers, Service Pack 2 or higher
must be installed for SCSI installations. Computers without
Service Pack 2 or higher will not be supported.
On Windows™ XP Professional Edition, Service Pack 1 or
higher must be installed for SCSI installations.
VIDAR’
s STI device driver provides compatibility between VIDAR film
digitizers/sca
nners and W
i
ndows™ 2000 and
Windows™ XP only.
The STI driver takes advantage of Microsoft’s Still Image Architecture
(STI) for digital imaging devices.
You will need:
VIDAR Drivers and Toolkit Installation
CD.
Note: These instructions have been successfully tested on a
wide range of Windows™ 2000 and Windows™ XP systems. In
rare instances, you may have difficulty installing the STI driver.
If that happens, try again after logging on as Administrator, or as
a user with Administrator rights.
1.
Be sure the digitizer is turned OFF, and is NOT
connected to the PC.
W
ait until you are prompted to connect the digitizer
.
2.
Turn on th
e PC.
3. Insert
the VI
DAR D
r
iver
s and Toolkit Installation CD into the CD-
ROM. The installer should launch automatically
.
VIDAR Advantage Series Installation and Operation Guide
To Next Page
Loading...
