69
Installing the USB drivers
Y
ou will need:
VIDAR Drivers and Toolkit Installation CD.
Note: These instructions have been successfully tested on a
wide range of Windows™ 2000 and Windows™ XP systems. In
rare instances, you may have difficulty installing the STI driver.
If that happens, try again after logging on as Administrator, or as
a user with Administrator rights.
1. Be sur
e the digitizer is turned OFF, and is NOT co
nnected to the
PC. W
ait until
you are prompted to connect the digitizer
.
Note: If the USB cable is connected to the digitizer before
installing driver software and the hardware wizard is allowed to
install the drivers from the CD, you will be prompted to install the
CD each time the digitizer is moved to another USB port.
T
o correct this, the driver software will need to be installed twice.
The first time
will be done as det
ail
ed in step
s 1 through 19; the
second time will follow the same method with one exception: the
installation wizard will recognize that the software has been
installed and will give two options prior to installation – Remove or
Repair. Select Repair and continue with the process. After
completing this process, you will no longer need the CD if the
digitizer is moved to another USB port.
VIDAR Advantage Series Installation and Operation Guide
To Next Page
Loading...
