86
About films
The film
digitizer handles standard radiograph films up to 14" x 17"
(35.5cm
x 43
cm
).
Y
ou can feed multiple films (up to 25), and you can mix film sizes
ranging from 8" x 10" (20.
3cm x 24.5cm) to 14" x 17" (35.5cm x 43cm)
in one stack—as long as you follow the rules below.
IMPORTANT: Remove stickers, tape, staples, paper clips, etc.
from films before scanning. These may cause serious film
feeding problems and may damage the digitizer’s internal
mechanisms. Failure to remove extraneous items from
films will void your warranty.
Load film
s just as you would view them on a light box, with thess
qualifications:
Films less than 8" wide wil
l not be detected by the digitizer’s film
sensor, and therefore will not be staged or digitized.
CAUTION: Films smaller than 8" x 8" can fall into the internal
optics box and cause damage not covered by your warranty.
Do not load films more than 17" (43.2cm) long in the auto feeder.
(See “Digitizing a single film,
” later in this chapter, when loading
films longer than 17".)
VIDAR Advantage Series Installation and Operation Guide
To Next Page
Loading...
