6. Under the [DLP Composer Lite] screen, select [Flash Loader]. The Flash Loader screen appears.
7. Click [Browse] and select the firmware [xxxxxxxxx.img] file to update your projector.
8. Make sure [Skip Boot Loader Area] is checked, and its value is [32KB].
9. Press and hold the Enter and Power buttons simultaneously on the projector keypad and then plug in
the power cord on the projector until the projector Temp LED and Lamp LED are lit up. This indicates
that the projector is in the firmware download mode.
10. Click [Reset Bus] to reset and verify good USB connection.
11.
Click [Start Download].
Confidential - Do Not Copy
ViewSonic Corporation
PJD6531w
To Next Page
Loading...
