ViewSonic SC-T46 - Resetting Your SC-T46 to the Factory Default

183
183
A.1 Resetting Your SC-T46 to the Factory Default
To reset your SC-T46 to the factory default, please do the following:
WARNING
• Resetting your SC-T46 to the factory default will erase all current settings in
ViewSonic Client Setup and restore all settings to defaults.
1. Restart your SC-T46.
1. During the POST (Power-on Self-Test) period, press Esc on the keyboard to enter ViewSonic Thin Client Menu.
ViewSonic Thin Client Menu
Normal Mode
Safe Mode
Reset Mode
Firmware update
Reboot
Shutdown
NOTE
• You might need to wait about 15 seconds for this menu to appear on the screen.
• Six options are available on ViewSonic Thin Client Menu: Normal Mode, Safe Mode,
Reset Mode, Firmware update, Reboot, and Shutdown. See the table below for
the description of each option:
Menu Option Description
Normal Mode Boots up your SC-T46 as the normal startup procedure.
Safe Mode Clears and resets the current screen resolution setting.
Reset Mode Resets your SC-T46 to the factory default.
Firmware update Updates rmware for your SC-T46 through the network.
Reboot Reboots your SC-T46.
Shutdown Shuts down your SC-T46.
2. Use arrow keys on the keyboard to select Reset Mode, and then press Enter on the keyboard to continue.
3. A message appears prompting for conrmation. Click y on the keyboard to conrm.
4. After completion, press Enter on the keyboard to restart your system.