ViewSonic SC-T46 - Creating the Mapping of IP Addresses to Names of Host Servers

Conguring Client Settings
Conguring Network Settings
88
88
4.5.7 Creating the Mapping of IP Addresses to Names of Host Servers
ViewSonic Client Setup allows you to use the name or alias of a host server instead of its IP address wherever you
need to specify an IP address while conguring client settings. To use this feature, rst you need to create the
mapping of IP addresses to names or aliases of host servers.
Creating the Mapping List
To create the mapping of IP addresses to names or aliases, please do the following:
1. On ViewSonic Client Setup, click Network > Hosts to open the Mapping list.
2. Click Add to start adding a new mapping entry.
3. Type in the name, IP address, and alias of a host server, and then click Save to apply.
NOTE
• If your host server belongs to a domain, please don’t enter the FQDN (Fully Qualied
Domain Name) or full computer name in the Hostname eld. Enter only the
computer name of the host server in this required eld.