ViewSonic SC-T46 - Updating Firmware for Your SC-T46

184
184
A.2 Updating Firmware for Your SC-T46
Four ways are available to update rmware for your SC-T46:
Method Description
ViewSonic Thin Client Menu Downloads rmware from a remote computer and updates rmware for your thin client.
ViewSonic Client Setup
Initiates rmware update locally on the thin client with the help of ViewSonic Client
Setup.
ViewSonic Device Manger
Initiates rmware update remotely on the remote computer with ViewSonic Device
Manager.
Using ViewSonic Thin Client Menu
To update rmware using ViewSonic Thin Client Menu, please do the following:
1. Connect your thin client to the network, and then restart it.
2. During the POST (Power-On Self-Test) period, press Esc on the keyboard to enter ViewSonic Thin Client Menu.
3. Select Firmware update and then follow the on-screen instructions to complete the task.
NOTE
• You need to specify the IP address of the rmware server over the network. A
rmware server is the server where ViewSonic Device Manager is installed and client
rmware les are imported through ViewSonic Device Manager.
• For more information about ViewSonic Device Manager, please refer to the User’s
Manual for ViewSonic Device Manager.
Using ViewSonic Client Setup
To update rmware using ViewSonic Client Setup, please refer to section “4.2.6 Updating Firmware from the
Management Computer” on page 43.
Using ViewSonic Device Manager
To update rmware using ViewSonic Device Manager, please refer to the User’s Manual for ViewSonic Device
Manager.