ViewSonic SC-T46 - Disabling or Enabling Attached Audio Devices

Conguring Client Settings
Conguring External Device Settings
72
72
4.4.5 Disabling or Enabling Attached Audio Devices
To disable/enable attached audio devices, please do the following:
NOTE
• If you disable locally attached audio devices, client users are not allowed to perform
audio playback or recording with these devices in an RDP / ICA / View session.
• To perform audio playback or recording with local audio devices in an RDP / ICA /
View session, you need to enable locally attached audio devices here
(the Audio setting item under Devices tab) and congure audio related settings
in the RDP / ICA / View connection settings. For detailed instructions, please
refer to sections:
 “4.6.5 Conguring Advanced RDP Connection Settings” on page 114
 “4.6.8 Conguring Advanced ICA Connection Settings” on page 148
 “4.6.11 Conguring Advanced View Connection Settings” on page 176
1. On ViewSonic Client Setup, click Devices > Audio.
2. Click to check/uncheck Enable System Audio Device.
3. Click Save to conrm your selection.
NOTE
• The change will not take eect until SC-T46 has been restarted.