ViewSonic SC-T46 - Page 57

Conguring Client Settings
Conguring System Settings
46
46
NOTE
• Please note that the Autostart mode also enables the client to start up directly with
an RDP / ICA / View session and provides more conguration exibility than the
Appliance mode. For detailed information on the Autostart mode, please refer to
the following sections:
 “4.6.5 Conguring Advanced RDP Connection Settings” on page 114
 “4.6.8 Conguring Advanced ICA Connection Settings” on page 148
 “4.6.11 Conguring Advanced View Connection Settings” on page 176
1. On ViewSonic Client Setup, click System > Appliance Mode.
2. Click to check Enable Appliance Mode.
3. Other settings of the Appliance mode appear.