4. After the load animation choose in the register Select PLC-
System the system "VIPA SPEED7" and click to [Create]. A new
station is created.
5. Save the empty station with [Strg]+[S].
6. By double click or drag&drop the according VIPA CPU in the
hardware catalog at ‘CPU SPEED7’ the CPU is inserted to your
configuration.
7. For output place a digital output module, assign the start
address 124 and save the hardware configuration.
Establish online access via Ethernet PG/OP channel:
1. Open the CPU-Properties, by double clicking to the CPU at slot
2 in the hardware configurator.
2. Click to the button [Ethernet CP-Properties (PG/OP-channel)].
ð
The dialog ‘Properties CP343’ is opened.
3. Chose the register ‘Common Options’ .
4. Click to [Properties Ethernet].
5. Choose the subnet ‘PG_OP_Ethernet’ .
6. Enter a valid IP address-and a subnet mask. You may get this
from your system administrator.
7. Close every dialog window with [OK].
8. Select, if not already done, ‘Target: External TCP/IP direct’ .
9.
Open with ‘Online è Send configuration to the CPU
’ a dialog
with the same name.
10. Click to [Accessible nodes]. Please regard to use this function it
is necessary to install WinPCap before!
11. Choose your network card and click to [Determining accessible
nodes].
ð
After a waiting time every accessible station is listed. Here
your CPU with IP 0.0.0.0 is listed, too. To check this the
according MAC address is also listed. This MAC address
may be found at a label beneath the front flap of the CPU.
12. For the temporary setting of an IP address select you CPU and
click to [Temporary setting of the IP parameters]. Please enter
the same IP parameters, you configured in the CPU properties
and click to [Write Parameters].
13. Confirm the message concerning the overall reset of the CPU.
ð
The IP parameters are transferred to the CPU and the list of
accessible stations is refreshed.
14. Select your CPU and click to [Confirm].
ð
Now you are back in the dialog "Send configuration".
Transfer hardware configuration
Choose your network card and click to [Send configuration].
ð
After a short time a message is displayed concerning the
transfer of the configuration is finished.
VIPA System 300S WinPLC7
Example project engineering > Project engineering
HB140 | CPU-SC | 312-5BE13 | GB | 15-50 169
To Next Page
Loading...